Operating Instructions
Starting the Washer
A.
Load the clothes in the cylinder and latch the door.
Check to insure that clothes do not get caught
between the door gasket and the tub front.
B.
Make the appropriate cycle selection for the wash
load using the 4-position rotary selector switch.
C.
Make the appropriate temperature selection for the
wash load using the 4-push button temperature
selector switch.
D.
To manually add wash compounds, pour low-
sudsing powdered detergent in the amount shown
below into the detergent dispenser on top of the
machine. Rinse conditioners may also be added
to the dispenser. The correct location is shown on
the dispenser lid.
E.
To manually add bleach in Rinse, pour bleach in
round opening (location shown on dispenser lid) in
top of washer.
F.
To start the washer:
1.
The top (Off/On) and bottom (Pause/Run)
rocker switches must be in the right hand
position.
2.
The center (Advance/Start) rocker switch
must then be pushed to the right hand
position to begin the cycle.
G.
To rapid advance the washer during a cycle, push
the center (Advance/Start) rocker switch to the left
hand position.
H.
To pause for an extended soak, push the bottom (Pause/Run) rocker switch to the left hand
position.
I.
To stop the wash cycle and drain the water, push the top (On/Off) button to the left hand
position.
Safety Door Lock
If power is interrupted the Safety Door Lock delays opening the door until it is safe to do so. If power
failure occurs or if power is interrupted during maintenance, it will be necessary to wait 2 to 3 minutes
before the door can be opened.
End of Cycle
When the cycle is completed, the washer will stop, the on light will go off, and the loading door will
unlock. It can be opened by turning the door handle to the indicated position and pulling. Leave the
clothes door open when the machine is not in use.
Detergent Measurements
By Washer Model
Maxi Load T-900 Washer
25
24
25
Part # 8533-031-001 6/22
Part # 8533-031-001 6/22
Notes
Machine
Mounting
Installation
& Operation
Trouble-
shooting
Machine
Service
Electrical
Wiring
Parts
Data
Coin
Handling
Maintenance
