MWP141-P1M 27MHz Wireless Optical Mouse page 2 of 8
1.0 Edition
off power, and low-power indicator on the receiver will blink to indicate battery status makes
MWP141 a smart companion for laptop users.
Package Contains
Your Wireless Optical Mouse package includes the following:
1.
The Wireless Optical mouse (MWP141-P1M)
2.
Ultra mini USB storable receiver (RX28-1M)
3.
User’s manual
4.
2 AAA Alkaline batteries
Note
：
If any part is missing, please contact your dealer for a replacement immediately.
Precaution
The optical mouse
can not
work on a glass or mirror surface. Avoid operating this mouse on
a glossy surface; otherwise, this mouse may not operate normally.
For consideration of saving battery power, it is strongly recommended to operate an optical
mouse on a bright surface with fine texture to obtain lower power consumption of the high
illumination LED. A very dark surface will cause higher power consumption.
For optimal performance, place the receiver at least 8 inches or 20 centimeters away from
other electrical devices, such as the computer, the computer monitor, speakers or other external
storage drives.
For a better transmission distance, avoid using this device on a metal plate or desktop
because a large surface of iron, aluminum, copper and other metal will act as a shield or ground
to the RF antenna of the mouse and receiver. Operating on a metal surface may shorten the
transmission distance.
If your notebook computer has a metal (contains Al or Mg) case, the metal housing of the
LCD panel will isolate partial radiation of the RF signal from the mouse. This could possibly
result in reducing the distance of transmission when you operate the mouse right in front of the
notebook and when the receiver is connected on the back of the notebook. However, the RF
mouse should work properly while you are operating the mouse just beside your desktop
computer.
