Figure N
Figure N
Figure M
Figure M
Figure L
Figure L
Figure K
Figure K
Figure J
Figure J
Figure I
Figure I
Figure H
Figure H
Figure G
Figure G
Figure F
Figure F
Figure E
Figure E
Figure D
Figure D
LOWER SLEEVE
Figure C
Figure C
Figure B
Figure B
Please rest assured that these instructions are very easy to follow and
will help you assemble this rail very quickly and WITHOUT TOOLS!
01. Lay all pieces out on the floor or table. (Figure A)
02. Connect the 2 Curved Bars until they lock into place. (Figure B)
Make sure silver button protrudes from hole in bar when finished.
(Figure C)
03. Insert assembled Curved Bar into Mesh Cover, leaving the ends of Curved
Bar exposed. (Figure D)
04. Open Hinged Legs until hinges lock firmly into place. (Figure E)
NOTE: Make sure Safety Straps are not twisted.
05. Connect Hinged Legs to Curved Bar until they lock into place (Figure F),
making sure that the sleeve in the middle of Mesh Cover faces inward toward
the outstretched Hinged Legs. (see assembled photo below)
Make sure silver button protrudes from hole in bar when finished.
(Figure C)
06. Slide Mesh Cover down toward each hinge.
07. Connect the 2 Round Lower Bars until they lock into place. (Figure G)
Make sure silver button protrudes from hole in bar when finished.
(Figure C)
08. Depress silver button on plastic slide-lock end of the Lower Bar (Figure G)
and slide this section into the “UNLOCK” position.
09. Insert “V” grooved end of assembled Lower Bar (Figure G) into the lower
sleeve of the Mesh Cover (see assembled photo below) matching the “V” end
of the bar with the “V” end at the base of the Hinged Leg. (Figure H)
Press firmly into place.
10. Align the plastic slide-lock end of the Lower Bar to the fitting on remaining
Hinged Leg and slide locking sleeve over the fitting until the spring-loaded
button snaps firmly into place. (Figure I and Figure J)
11. Connect the 2 Square Stabilizer Bars. (Figure K)
Make sure silver button protrudes from hole in bar when finished.
12. Insert assembled Stabilizer Bar (Figure K) into the sleeve in the middle of
Mesh Cover and close velcro flap. (Figures L and M)
13. Connect Anchor Strap and Plate to Safety Strap attached to Hinged Legs.
(Figure N)
ASSEMBLY INSTRUCTIONS
LOWER SLEEVE
SLEEVE IN MIDDLE
OF MESH COVER
MUST FACE INWARD
TOWARD LEGS