NOTE – all data and credential information you provide will be stored in Dexatek’s account, and accessible to Dexatek. If
you have any questions or concerns, please reach out to our support team at [email protected]/ +886 2 8698
4245 #828
7
Setup your hardware
1.
Connect your IoT device (e.g. sensor….)
2.
Plug in the USB Power
3.
Turn on the power switch
8
Build the demo
https://www.dexatek.com/aws-lot-core-dk9169
9
Run the demo
Go to the demo APP main page select the interface your device is connected to
(1)
Select
“I2C”
Tab to read /write I2C data
(2)
Select
“GPIO”
Tab to monitor GPIO is High/Low status
(3)
Select
“UART”
Tab to read / write UART RX & TX data
10
Troubleshooting
1.
Check power indicator to make sure power supply is properly connected.
2.
Use minimum 1A current power supply to ensure sufficient power
3.
Follow point
8
to connected device
.
4.
Power off and check your device connect to connector as well
.
7.1 Download the latest version of the “
User Guide for installation of the Demo App
at product web page as
below link. Follow the steps in the User Guide to download and install the app on the phone.