Installation
c
Danger:
Take care not to damage any gas, electricity or telecommunication lines
when fitting the device. Danger to life and risk of injury and damage.
Tip:
to cut costs, connect the device for continuous operation to a 9 volt mains
adapter for the power supply.
The mini-alarm can be installed to monitor an area permanently – this is recommend-
ed for continuous operation, e.g. at the entrance to your home. You can position the
mini-alarm by adjusting its angle on the mounting bracket.
o
Remove the mounting bracket carefully from the mini-alarm.
o
Hold the mounting bracket in the position you wish to install it and mark the
holes in the rectangular surface of the mounting bracket
W
with the pen.
o
Screw the mounting bracket carefully in position with the fastening screws
Y
.
o
Mount the mini-alarm carefully on the mounting bracket and check that it is
properly positioned.
Tip:
you can also set up the mini-alarm to monitor an area for a short period of
time – this is recommended for travel use, e.g. in your hotel room.
o
Place the mini-alarm on e.g. a piece of furniture and check that it is properly
positioned.
Activating / deactivating alarm functions
m
Danger
o
Do not use the device in the presence of sick or disabled people and animals.
Shock caused by the siren can endanger life and poses a risk of injury.
o
Make sure that your hearing is not exposed to the loud siren for any length of
time. This can cause serious damage to the hearing.
o
Make sure that the alarm is not triggered close to the ears. This can cause serious
damage to the hearing.
Functions
You can control the function of the mini-alarm with the function switch and by con-
necting it to a bell push or other type of make contact.
-
Activating the chime function
o
Set the function switch to position
The mini-alarm registers movement of a heat-emitting body with a two-tone chime.
-
Activating the alarm function
o
Set the function switch to position
o
Leave the sensing range of the mini-alarm within the ON delay of approx.
15 seconds. The mini-alarm subsequently registers movement by a heat-emitting
body with a siren lasting approx. 30 sec.
0 -
Deactivating the alarm / chime function
o
Set the function switch to position 0.
o
Monitoring of the sensing range is deacctivated.
T62_MA604_GB.indd 6
12.09.2006 11:32:35 Uhr
