DeWalt DWE315-XE, Инструкция по эксплуатации

Страница: 8 / 12

6
CAUTION: Read and follow all manufacturers' safety warnings for any accessories
used with this tool.
CAUTION: To avoid injury, ensure adaptor and accessory are securely tightened.
Attaching the Cut Guide (Fig. 7–12)
The depth/cut guide allows you to precisely cut
material at a specified depth and more accurately
track a marked cut line.
1. Attach the cut guide block (F) by inserting the
tabs (M) on the guide into the accessory side
mount (E) on the main body of the tool.
2. Secure the block to the main body with the
supplied screw (O). Tighten with the supplied hex
wrench (P).
DEPTH GUIDE
This feature allows you to precisely cut material at a
specified depth.
1. Insert the guide arm (G) as shown in Figure 8
into the front slot on the guide block (F).
2. Adjust the length of the guide by pulling out or
pushing inward to achieve the desired cut depth
as shown in Figure 9.
3. Secure the guide in place by turning the depth/cut adjustment knob
(N) clockwise. To release the guide turn the depth/cut adjustment knob
counterclockwise.
N
FIG. 8 FIG. 9
F
G
E
M
O
P
F
FIG. 7
CUT GUIDE
This feature allows you to more accurately track a marked cut line.
1. Insert the guide arm (G) as shown in figure 10 into the slots on the left and right
sides of the guide block (F).
2. Adjust the length of the guide by pulling out or pushing inward to achieve the
desired length as shown in Figure 11.
3. Secure the guide in place by turning the depth/cut adjustment knob
(N) clockwise. To release the guide turn the depth/cut adjustment knob
counterclockwise.
NOTE: The cut guide block and the cut guide arm are available on selected model
only.
N
FIG. 10 FIG. 11
F
G
NOTE: The guide arm can also be placed in the guard
assembly vertically in order to set the height off a cut.
Refer to Figure 12.
Attaching the Dust Extraction Adaptor
(Fig. 13)
The Dust Extraction Adaptor allows you to connect
the tool to an external dust extractor, either using the
AirLock™ system (DWV9000-XJ) or a standard
35 mm dust extractor fitment.
1. Attach the dust extraction adaptor (Q) by inserting the tabs (M) in to the
accessory side mount slots (E).
2. Insert screw (O) and washer (R) into the dust extraction adaptor (Q) and tighten
with the supplied hex key (P).
FIG. 12