30
English
Voltage (Volts)
Total length of cord in meters (m)
120–127V
0–7
7–15
15–30
30–50
220–240V
0–15
15–30
30–60
60–100
Rated Ampere
range
Minimal cross-sectional area of the
cord in meters (mm
2
)
0–6A
1.0
1.5
1.5
2.5
6–10A
1.0
1.5
2.5
4.0
10–12A
1.5
1.5
2.5
4.0
12–16A
2.5
4.0
Not Recommended
WARNING:
ALWAYS
USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. All users and bystanders MUST ALWAYS
wear certified safety equipment:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
WARNING:
Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
•
Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water.
Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING:
Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use.
Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
WARNING: Always use eye protection.
All users and
bystanders must wear eye protection that conforms to ANSI Z87.1.
WARNING: When not in use, place grinder on a stable
surface where it will not move inadvertantly, roll or cause a
tripping or falling hazard.
Serious personal injury may result.
CAUTION:
To reduce the risk of personal injury, use extra care
when working into a corner or edge because a sudden, sharp
movement of the tool may be experienced when the wheel or other
accessory contacts a secondary surface or a surface edge.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V .......... volts
A .......... amperes
Hz ........ hertz
W......... watts
min ...... minutes
....... alternating current
... direct current
....... alternating or direct current
........ Class I Construction no ........ no load speed
............
............
(grounded)
........ earthing terminal
........ Class II Construction
......... safety alert symbol
............
(double insulated)
BPM .... beats per minute
