2
English
ASSEMBLY
DW7231 D
E
WALT Miter Saw Mounting
Method (Fig. 2, 3)
WARNING: To reduce the risk of injury, turn unit off,
disconnect machine from power source before assembling
the miter saw to the miter saw stand.
An accidental start-up can
cause injury.
WARNING:
Stability Hazard. You must use the
Universal
Miter Saw Mounting Method
when mounting a miter saw not
manufactured by D
E
WALT to this miter saw stand.
WARNING:
To reduce the risk of personal injury, be sure the miter
saw is fully anchored on the stand.
WARNING:
For your own safety, read and understand the
miter saw
instruction manual before using. Failure to heed these warnings may
result in personal injury and serious damage to the miter saw and the
accessory.
1. Place saw in operational position with blade facing you. Align with
label on the mounting bracket showing front.
2. Place a spacer, such as a 2 x 4, under one side of the miter saw
to hold the saw’s mounting feet above the work surface.
3. Hold a mounting bracket under the saw and feed a carriage bolt
(hardware bag) up through the bracket and the foot of the saw.
NOTE:
See
DW7231 Hardware Selection Chart
for the correct
mounting hardware procedures for D
E
WALT miter saws. Follow all
instructions properly, otherwise the miter saw's table rotation may
be obstructed.
DW7231 HARDWARE SELECTION CHART
Left Side
Right Side
DW703
1
1
DW705
1
1
DW706
1
1
DW708
1
2
DW712
1
2
DW713
1
1
DW715
1
1
DW716
1
1
DW717
2
1
DW718
3
2
DWS780
3
2
1 = Long screw, Head on bottom
2 = Short screw, Head on bottom
3 = Long screw, Head on top
4. Once the carriage bolt (hardware bag) is installed per
DW7231
Hardware Selection Chart
, assemble a flat washer, lock washer
and nut onto the bolt. Tighten the bolts finger tight.