33
Electrical Connection
The electric motor has been designed for one voltage only. Always check that the power supply
corresponds to the voltage on the rating plate. 230 V AC means your tool will operate on alternating
current. As little as 10% lower voltage can cause loss of power and can result in overheating.
All D
E
WALT tools are factory tested; if this tool does not operate, check the power supply. Your
D
E
WALT tool is double insulated, therefore no earth wire is required.
•
Young children and the infirm.
This appliance is not intended for use by young children or
infirm persons without supervision. Young children should be supervised to ensure that they do
not play with this appliance.
•
Replacement of the supply cord.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised D
E
WALT Service Centre in order to avoid a hazard.
Accessories
WARNING:
Since accessories, other than those offered by D
E
WALT, have not been tested with
this product, use of such accessories with this tool could be hazardous. To reduce the risk of
injury, only D
E
WALT, recommended accessories should be used with this product.
If you need any assistance in locating any accessory, please contact: DeWALT Industrial Tool Co.,
20 Fletcher Road, Mooroolbark, VIC 3138 Australia, call 1800 654 155 or 5 Te Apunga Place, Mt
Wellington, Auckland, New Zealand, call 09 259 1111.
Optional Accessories
The following accessories, designed for your saw, may be helpful. In some cases, other locally
obtained work supports, length stops, clamps, etc., may be more appropriate. Use care in selecting
and using accessories.
Laser Guide System: DW7187
Powered by the saw, the bright laser line delivers enhanced visibility in low and high light
locations. Easy to install.
Miter Saw LED Worklight System: DWS7085
Lighting used for greater visibility and cutting alignment during operation. Easy to install.
Extension, Work Support: DW7080
Used to support long overhanging workpieces, the work support is user assembled. Your saw
table is designed to accept two work supports; one on each side.
Clamp: DW7082 (similar model included)
Used for firmly clamping workpiece to the saw table for precision cutting.
Dust Bag: DW7053 (Included with some models)
Equipped with a zipper for easy emptying, the dust bag will capture the majority of the sawdust
produced (not shown).
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
SAW BLADES:
ALWAYS USE 254 mm (10") SAW BLADES WITH 15.88 mm (5/8") ARBOR HOLES.
SPEED RATING MUST BE AT LEAST 5500 RPM. Never use a smaller diameter blade. It will not be
guarded properly. Use crosscut blades only! Do not use blades designed for ripping, combination
blades or blades with hook angles in excess of 5
˚
.
BLADE DESCRIPTIONS
APPLICATION
DIAMETER
TEETH
Construction Saw Blades
(thin kerf with anti-stick rim)
General Purpose
10"
40
Fine Crosscuts
10"
60
NOTE:
Thin kerf 60T blades without noise damping may ring under no load
conditions.
Woodworking Saw Blades
(provide smooth, clean cuts)
Fine crosscuts
10"
80
Non-ferrous metals
10"
80
NOTE:
For cutting non-ferrous metals, use only saw blades designed for this
purpose.
DW7082
DW7084
LOCKNUTS
END PLATE
DW7080
DW7187
DWS7085
