Spade Handle
The spade handle is installed as shown in Figure 1. Tighten the two
screws securely.
NOTE: The spade handle can be removed from the tool if additional
working clearance is needed. Always operate drill with side handle or
spade handle. Either handle may be removed but never remove
both handles at once!
3
English
FIG. 6
FIG. 7
CHUCK
SPADE HANDLE
SIDE HANDLE
REVERSING
SWITCH
TRIGGER
SWITCH
TRIGGER
LOCK BUTTON
BRUSH
INSPECTION CAP
Side Handle
CAUTION: Always use and hold firmly the side handle or spade
handle. This is a high-torque drill- always hold it with both hands
when operating. The side handle screws into the large hole in the
top of the tool.
Switch
To turn the tool ON, depress the trigger switch. To turn the tool OFF,
release the trigger switch. (See Figure 2).
The toggle switch above the trigger is the reversing switch. Switch
this toggle only when the tool is not running or coasting. After
reversing operations are completed, switch the toggle back to
forward position.
To lock the tool ON, depress the trigger and push in the lock button.
Then, while holding the lock button in position, gently release the
trigger. To release locking mechanism, depress trigger fully, then
release it. Do not lock the switch ON when drilling by hand so that
you can instantly release the trigger switch if the bit binds in the hole.
The locking feature is for use when the drill is mounted in a drill stand
or otherwise firmly held. THE LOCKING FEATURE IS NOT FOR
USE WHEN DRILLING BY HAND. Be sure to release the switch
lock button before disconnecting the tool from the power supply.
Failure to do so will cause the tool to start immediately the next time
it is plugged in. Damage or injury could result.
DW131/DW132/384028 5/2/02 3:22 PM Page 3
