17
english
h. Carry handle
i. Locking locator clip
j. Leg lock lever
k. Release button
INTENDED USE
Your mitre saw stand has been designed to extend
the versatility of your D
e
WALT mitre saw.
DO NOT
use under wet conditions or in presence of
flammable liquids or gases.
These mitre saw stands are professional power
tools.
DO NOT
let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING:
Always observe the safety
instructions and applicable regulations.
Preparation (fig. 2)
1. Place the mitre saw stand on the ground with
the folded legs facing up.
2. Depress the leg lock lever (j) or release button
(k) and pull leg up until the locking pin clicks into
place. Repeat on each leg.
3. Lift the stand by the center beam and place it in
an upright position. The stand should be stable
and should not rock.
NOTE:
Ensure all locking pins are engaged and the
legs are locked in place.
DE7024 Work Support/Stop (fig. 3, 4)
a. The work support/stop (d) has a clamp (l)
to capture the beam and keep it from being
knocked off the beam by your material.
The knob (m) may be locked by turning
clockwise and the work support/stop is free
to be repositioned when the knob is turned
counterclockwise. Do not overtighten; firm
pressure on the knob will hold the stop in place.
b. Adjust the height of the work support/stop (d)
by loosening the knobs on both sides (n) and
raise or lower the top surface to align with a
straight edge or level to the saw table. Tighten
the knobs.
NOTE:
If the work support height adjustment
slips down when under a load, the weight limit
of the work support has been exceeded. This
weight limit is limited by the tightness of the
height adjustment knobs. Do not tighten more
than finger tight.
Residual Risks
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Risk of personal injury by sharp edges and
squeezing.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear eye protection.
DATE CODE POSITION (FIG. 1)
The Date Code (u), which also includes
the year of
manufacture, is printed into the housing.
Example:
2015 XX XX
Year of Manufacture
Package Contents
The package contains:
1 Mitre saw stand (DE7023 or DE7033)
2 Mitre saw mounting brackets (DE7025)
2 Work support/stop (DE7024)
1 Hardware bag
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1)
WARNING:
Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Beam
b. DE7025 Mitre saw mounting brackets
c. Extension arm
d. DE7024 Work support/stop
e. Extension arm end cap
f. Extension arm lock lever
g. Release levers
Содержание DE7023
