DeWalt DE0881-XE, Инструкция по эксплуатации, Страница: 5 / 8

3
Adjusting the Leg Height
1. Release the quick-adjust latch (B) of the first leg (C) to set the desired height.
Tighten the latch.
2. Repeat process for the other legs.
Mounting the Laser to the Tripod
The tripod has been equipped with a threaded pin for mounting of the DW088-XE and
DW089-XE lasers.
1. Install the tripod on a relatively smooth and level surface, using the bubble level
(J) as a guide.
2. Mount the laser to the tripod by turning the mounting thread (F) into the
receptacle in the base of the laser.
WARNING: Before mounting a laser to the tripod, check that the legs are firmly set
and that the tripod is wobble free.
Elevating the Head Mount
The head mount (A) can be elevated to a maximum height of 1.7 m. The laser is
operated using the elevator crank handle (D). Move the head mount to the desired
height and tighten the elevating lock knob (I).
Storage
In order to conveniently store the attachment, a carrying bag is included.
MAINTENANCE
Accessories
WARNING: Since accessories, other than those offered by D
E
WALT, have not been
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
E
WALT recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory, please
contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call
1800 444 224 or (NZ) 0800 339 258.