12
English
WARNING:
Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of the appliance. These
chemicals may weaken the plastic materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get
inside the appliance; never immerse any part of the appliance into a liquid.
CHarGer CLeanInG InSTruCTIonS
WARNING:
Shock hazard. Disconnect the charger
from the AC outlet before cleaning. Dirt and grease may be removed
from the exterior of the charger using a cloth or soft non-metallic
brush. Do not use water or any cleaning solutions.
FIG. 14
14B
14A
FIG. 15
15D
15B
15A
15C
15C
Replacing Brushes in motor (Fig. 14–18)
(DcST960 only)
Follow the instructions below to replace the brushes on the DCST960
string trimmer, or bring the trimmer to a D
e
WALT factory service
center, a D
e
WALT authorized service center, or other qualified service
personnel. Always use identical replacement parts.
1. Remove battery.
2. Using a T10 screwdriver, remove the four outer screws (14A)
from the cap (14B) of the motor housing (E) and pull the cap off of
the housing (Fig. 14).
(12C) of the spool. Align the holding slots (10C) with the two holes
(12A) as close as possible.
13. Push the spool into the spool housing and turn counterclockwise
to lock the spool in place. Ensure the white nub (12B) appears in
the spool window (9B).
14.
Pull both ends of the cutting line to release them from the
holding slots.
mAInTenAnce
WARNING:
To reduce the risk of serious
personal injury, turn appliance off and remove battery before
making any adjustments or removing/installing attachments
or accessories.
1. Keep the air intake slots (13A) clean
13A
FIG. 13
to avoid overheating.
2. Your trimmer line can dry out
over time. To keep your line in top
condition, store spare line in a plastic,
sealable bag with a tablespoon of
water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is
recommended you periodically touch-up the sharpness of the
blade with a file
.
cleaning
WARNING:
Blow dirt and dust out of all air vents
with clean, dry air at least once a week. To minimize the risk of
eye injury, always wear ANSI Z87.1 approved eye protection when
performing this.
