DeWalt DCS381-XE, Инструкция по эксплуатации

Страница: 11 / 16

9
WARNING: Cut hazard. Blade breakage may occur if the blade does not extend past
the shoe and the workpiece during the cut (Fig. 5). Increased risk of personal injury, as
well as damage to the shoe and workpiece may result.
FIG. 5
TO INSTALL BLADE INTO SAW
1. Pull blade clamp release lever (C) up (Fig. 6)
C
FIG. 6
2. Insert blade shank from the front.
3. Push blade clamp release lever down.
NOTE: The blade can be installed in the DCS380-XE
in four positions as shown in Figure 7. The blade
can be installed in the DCS381-XE in two positions
as shown in Figure 7. Both units allow the blade to
be installed upside-down to assist in flush-to cutting;
see Figure 11.
FIG. 7
DCS381-XE
DCS380-XE
TO REMOVE BLADE FROM SAW
CAUTION: Burn hazard. Do not touch the the blade immediately after use. Contact
with the blade may result in personal injury.
1. Open up blade clamp release lever.
2. Remove blade.