DeWalt DCR019-XE, Инструкция по эксплуатации

Страница: 10 / 12

8
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
Repairs
This charger and battery pack are not serviceable. Servicing at an authorized service
centre is required to avoid damage to static sensitive internal components.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
Accessories
WARNING: Since accessories, other than those offered by D
E
WALT, have not been
tested with this product, use of such accessories with this radio could be hazardous.
To reduce the risk of injury, only D
E
WALT recommended accessories should be used
with this product.
Recommended accessories for use with your radio are available at extra cost from
your local service center. If you need any assistance in locating any accessory, please
contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call
1800 338 002 or (NZ) 0800 339 258.
IMPORTANT RADIO NOTES (FIG. 6)
1. The radio will run up to 8 hours on a
fully charged 4.0 amp hour battery.
Using batteries of lower voltage or
capacity will produce less run time.
2. Reception will vary depending on
location and strength of radio signal.
3. Certain generators may cause
background noise.
4. AM reception will most likely be clearer
when powered by a battery pack.
5. To use the auxiliary port (I), plug the
output jack from a CD or iPod
®
*/MP3
player into the port (fig. 6). The sound
from the external source plays through
the speakers of the DCR019.
* iPod is a registered trademark of Apple Inc.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn the unit off and
disconnect the battery pack before making any adjustments or removing/installing
attachments or accessories. An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the unit. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the radio; never immerse any part of the radio into a liquid.
l
FIG. 6