English
8
1. Place the fan on the tripod's mounting screw using the
appropriate screw threads on the base of the fan.
2. Rotate the fan clockwise to attach.
Keyhole slots (Fig. E)
If using the keyhole slots
10
, use at least 2 screws, one on
each side, secured into a sturdy surface.
1. Place the wide portion of the keyhole slot over the head
of the screw.
2. Slide the jobsite fan down until the screw is inside the
narrow portion of the keyhole and check to be sure the
fan is secure.
Fig. E
8
9
10
10
Carrying the Fan (Fig. A)
Carry the fan using the top handle
4
.
Adjusting the Fan Angle (Fig. A)
WARNING:
Keep fingers away from the front and rear
grill of the fan.
This fan has soft detents to maintain multiple angles. To
adjust, gently push or pull the fan handle
4
.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off, disconnect from power
source and remove the battery packs before
making any adjustments or removing/installing
attachments or accessories.
An accidental start-up
can cause injury.
Installing and Removing the Battery Pack
(Fig. A, F)
nOTE:
For best results, make sure your battery pack is
fully charged.
To install the battery pack
6
into the fan, align the battery
pack with the rails inside the fan's battery nook
2
and slide
it in until the battery pack is firmly seated and ensure that it
does not disengage.
To remove the battery pack from the fan, press the release
button
7
and firmly pull the battery pack out of the fan's
battery nook. Insert it into the charger as described in the
charger section of this manual.
Fig. F
7
6
Using the AC Plug (Fig. A)
An extension cord can be plugged into the AC plug
3
then
into a wall outlet to power the fan. Lower the AC plug cover
to use. To keep the plug safe from moisture, remove the
extension cord then close the AC plug cover securely.
Turning the Fan On and Off (Fig. A)
To turn the fan ON, rotate the control knob
1
clockwise.
To turn the fan OFF, rotate the control knob
1
counterclockwise until it clicks.
Fan speeds are variable and can be adjusted by the
control knob.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off, disconnect from power
source and remove the battery packs before
making any adjustments or removing/installing
attachments or accessories.
An accidental start-up
can cause injury.
Cleaning
WARNING:
Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Accessories
WARNING:
Since accessories, other than those
offered by
D
e
WALT
, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
D
e
WALT
recommended accessories should be used with
this product.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact
D
e
WALT
Industrial
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-
D
e
WALT
(1-800-433-9258) or visit our website:
www.dewalt.com.
