DeWalt DC733-XE, Инструкция по эксплуатации, Страница: 11 / 16

9
Inserting and Removing Bits
P
FIG. 4
(Fig. 1, 4)
1. Open the chuck by turning the sleeve
(P) counterclockwise and insert the bit
shank.
2. Place the bit in the chuck as far as it
will go and lift slightly before tightening.
3. Tighten firmly by turning the sleeve
clockwise.
4. To remove the bit, proceed in reverse
order.
Selecting the Operating Mode or Adjusting the Torque (Fig. 5)
The collar of this tool has 15 positions for the adjustment of the torque to suit
the size of the screw and the workpiece material. For torque adjustment, refer to
Screwdriving .
Select the drilling mode or torque by aligning the symbol or number on the collar (E)
with the indicator (Q) on the housing.
B
FIG. 6
E
Q
P
FIG. 5
Forward/reverse Slider (Fig. 6)
To select forward or reverse rotation, use the forward/ reverse slider (B) as shown
(see arrows on tool).
WARNING: To reduce the risk of personal injury, always wait until the motor has
come to a complete standstill before changing the direction of rotation.
Two-gear Selector (Fig. 7)
F
FIG. 7
Your tool is fitted with a two-gear
selector (F) to vary the speed/
torque ratio.
1 low speed/high torque
(drilling large holes, driving
screws)
2 high speed/low torque
(drilling smaller holes)
For speed rates, refer to the
technical data.
WARNING: To reduce the risk of
personal injury, always push the
two gear selector completely
forward or backward.
WARNING: To reduce the risk of personal injury, Do not change gears at full speed
or during use.
OPERATION
Instructions for Use
WARNING: To reduce the risk of personal injury:
• Always observe the safety instructions and applicable regulations.
• Be aware of the location of pipework and wiring.
• Apply only a gentle pressure to the tool. Excessive force does not speed up
drilling but decreases tool performance and may shorten tool life.
• To minimise stalling on break-through, progressively reduce the drill point
pressure towards the end of the operation.