DeWalt DC411-XE, Инструкция по эксплуатации

Страница: 15 / 24

13
Installing and Removing the Battery Pack (Fig. 2, 3)
NOTE: Make sure your battery pack is fully charged.
O
To install the battery pack into the tool handle , align the notch inside the tool’s
handle with the battery pack and slide the battery pack firmly into the handle until you
hear the lock snap into place.
To remove the battery pack from the tool , press the release buttons (O) and firmly
pull the battery pack out of the tool handle. Insert it into the charger as described in the
charger section of this manual.
A
B
Unlocked
Locked
FIG. 3
Switch (Fig. 3)
LOCK-OFF BUTTON AND TRIGGER SWITCH
Your finishing grinder is equipped with a lock-off button (B).
To lock the trigger switch, press the lock-off button as shown in Figure 3. When the
lock-off button is depressed to the lock icon, the unit is locked.
Always lock the trigger switch when carrying or storing the tool to eliminate
unintentional starting.
To unlock the trigger switch, press the lock-off button. When the lock-off button is
depressed to the unlock icon, the unit is unlocked. The lock-off button is colored red to
indicate when the switch is in its unlocked position.
Pull the trigger switch (A) to turn the motor ON. Releasing the trigger switch turns the
motor OFF.
NOTE: This tool has no provision to lock the switch in the ON position, and should never
be locked ON by any other means.
CAUTION: Hold the side handle and body of the tool firmly to maintain control of
the tool at start up and during use and until the wheel or accessory stops rotating.
Make sure the wheel has come to a complete stop be fore laying the tool down.
CAUTION: Allow the tool to reach full speed before touching
tool to the work surface. Lift the tool from the work surface before turning the tool off.
SPINDLE LOCK
The spindle lock pin is provided to prevent the spindle from rotating when installing
or removing wheels. Operate the spindle lock pin only when the tool is turned off, the
battery is removed, and the wheel has come to a complete stop.
CAUTION : To reduce the risk of damage to the tool, do not engage the spindle lock
while the tool is operating. Damage to the tool will result and attached accessory may
spin off possibly resulting in injury.
To engage the lock, depress the spindle lock button and rotate the spindle until you
are unable to rotate the spindle further.