29
English
To Carry (Fig. 1)
Fold down unit to position where you can carry the saw. Hook lock
chain (A) to lock arm down.
Unlocking (Fig. 1)
To unlock tool and raise head, depress motor arm slightly and unhook
lock chain (A) out. Motor arm will then pivot upward.
Material Clamping and Supporting
(Fig. 2, 3)
• Angles are best clamped and cut with both legs resting against
base.
• A spacer block slightly narrower than the workpiece can be used
to increase wheel utilization (Fig. 2).
• Long workpieces must be supported by a block so it will be level
with top of base (Fig. 3). The cut off end should be free to fall
downward to avoid wheel binding.
FIG. 2
DIAMETER OF WORKPIECE
WIDTH OF SPACER BLOCK
SPACER
BLOCK
E
F
FIG. 1
O
G
C
B
L
K
J
F
H
G
E
D
I
A
N
M
Q
P
OPERATION
WARNING:
Always observe the safety instructions and applicable
regulations.
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories.
Be sure the
trigger switch is in the OFF position. An accidental start-up can cause
injury.
