DeWalt D284076, Инструкция по эксплуатации

Страница: 17 / 56

English
15
2. Install wheel backing flange, aligning flats on spindle (O) with
flats on backing flange (R).
3. Place the wheel on the backing flange, centering the wheel on
the backing flange pilot.
4. Install the clamp nut, ensuring that the wheel remains centered
on the backing flange.
5. Depress the spindle lock button and tighten clamp nut with
wrench.
6. Reverse the above procedure to remove the wheel.
USING CUTTING WHEELS
1. Allow tool to reach full speed before touching tool to work sur-
face.
2. Apply minimum pressure to work surface, allowing tool to oper-
ate at high speed.
3. Once you begin a cut, maintain the angle of the cutting wheel to
the work surface. This will keep you from bending the wheel
which could result in wheel breakage and injury.
4. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before setting it down.
MAINTENANCE
Cleaning
Blowing dust and grit out of the motor housing using clean, dry
compressed air is a necessary regular maintenance procedure.
Dust and grit containing metal particles often accumulate on interior
surfaces and could create an electrical shock hazard if not fre-
quently cleaned out. ALWAYS WEAR SAFETY GLASSES.
CAUTION: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. Use a clean, dry rag only.
Lubrication
D
E
WALT tools are properly lubricated at the factory and are ready
for use.
Repairs
To assure product SAFETY and RELIABILITY, repairs, mainte-
nance and adjustment should be performed by authorized service
centers or other qualified service personnel. Always use identical
replacement parts.
Motor Brushes
When brushes become worn, the tool will automatically stop, pre-
venting damage to the motor. Brush replacement should be per-
formed by D
E
WALT authorized service centers or other qualified
service personnel. Qualified service personnel should follow the
procedures below when replacing motor brushes.
Turn off and unplug tool before making any adjustments or
removing or installing accessories. Before reconnecting the
tool, depress and release the trigger switch to ensure that the
tool is off.
1. Remove the brush doors located on the sides of motor housing.
2. To remove the brush, hold the female terminal, which is attached
to the brush lead wire, and disconnect the female terminal from
the male terminal.
3. Pull the brush straight up out of the brush holder.
4. Replace brushes, in pairs, with original D
E
WALT brushes avail-
able from D
E
WALT authorized service centers.
5. Ensure that the brushes slide freely in brush box.
6. Reconnect the brush lead wire to brush box terminal.
643855-00,D28474,B3 10/3/06 11:38 AM Page 15