DeWalt D28116-XE, Инструкция по эксплуатации

Страница: 10 / 16

8
Setting the Electronic Speed Control (fig. 1)
D28116, D28117, D28136, D28137
Turn the dial (E) to the desired level. Turn the dial upwards for higher speed and
downwards for lower speed. The required setting is a matter of experience.
E.g.:
– when cutting in soft, brittle materials, set the dial to a low setting;
– when cutting in harder materials, set the dial to a high setting.
OPERATION
WARNING: Ensure all materials to be ground or cut are secured in place.
WARNING: Avoid overloading. Should the tool become hot, let it run a few minutes
under no load condition. Apply only a gentle pressure to the tool.
WARNING: Do not exert side pressure on the disc.
Guards and Flanges
It is important to choose the correct guards and flanges to use with the grinder
accessories. See pages 7–8 for the correct accessories.
NOTE: Edge grinding and cutting can be performed with Type 27 wheels designed
and specified for this purpose.
WARNING: Accessories must be rated for at least the speed recommended on the
tool warning label. Wheels and other accessories running over rated accessory speed
may burst and cause injury. Every unthreaded accessory must have a 22 mm (7/8")
arbor hole. If it does not, it may have been designed for a circular saw and should not
be used. Use only the accessories shown on pages 7–8. Accessory ratings must be
above listed minimum wheel speed as shown on tool nameplate.
Type 1 guard
backing flange
abrasive cutting wheel
clamp nut
Cutting Wheels
Type 27 guard
hubbed sanding
flap disc
Type 1 guard
backing flange
diamond cutting wheel
clamp nut
Sanding Discs
rubber backing pad
sanding disc
threaded clamp nut
Sanding Flap Discs
Type 27 guard
backing flange
non-hubbed
sanding flap disc
threaded clamp nut