31
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the disc.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
PRIOR TO OPERATION:
• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer fl ange are mounted
correctly.
• Make sure the disc or wheel rotates in the direction
of the arrows on the accessory and the tool.
SWITCHING ON AND OFF (FIG. A)
• To run the tool, press the on/off switch (1).
• For continuous operation, press the switch
completely forward.
• To stop the tool, release the switch. To stop the
tool in continuous operation, press on the back
part of the switch.
WARNING:
Do not switch the tool on or
off when under load.
METAL APPLICATIONS
• When using the tool in metal applications, make
sure that a residual current device (RCD) has
been inserted to avoid residual risks caused by
metal swarf.
• If the power supply is shut off by the RCD, take
the tool to authorised D
E
WALT repair agent.
WARNING:
In extreme working
conditions, conductive dust can
accumulate inside the machine housing
when working with metal. This can result
in the protective insulation in the machine
becoming degraded with a potential risk
of an electrical shock.
To avoid build-up of metal swarf inside the machine,
we recommend to clear the ventilation slots on a
daily basis. See “Maintenance”.
USING FLAP DISCS
WARNING:
Metal dust build-up
• Extensive use of fl ap discs in metal applications
can result in the increased potential for electric
shock. To reduce this risk, insert an RCD before
use and clean the ventilation slots daily by
blowing dry compressed air into the ventilation
slots in accordance with the below maintenance
instructions.
Optional accessories
WARNING:
Since accessories, other
than those offered by D
E
WALT, have
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
E
WALT, recommended
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
E
WALT power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
POP-OFF BRUSHES
The motor will be automatically shut off indicating
that the carbon brushes are nearly worn out and that
the tool needs servicing. The carbon brushes are
not user-serviceable. Take the tool to an authorised
D
E
WALT repair agent.
LUBRICATION
Your power tool requires no additional lubrication.
E N G L I S H
Содержание D28111
Страница 1: ...1 D28111 D28113 K D28130 D28132C D28134 D28135 K D28139 D28141 www eu ...
Страница 3: ...1 A 1 2 3 4 ...
Страница 4: ...2 14 12 10 11 A B 14 12 10 11 14 12 10 11 13 2 7 5 3 6 6 B1 C1 C2 8 5 9 3 6 6 B2 ...
Страница 5: ...3 4 15 15 D ...
