DeWalt D23620-XE, Инструкция по эксплуатации

Страница: 9 / 12

9
3. Loosen the bevel adjustment knob (I).
4. Place a square against the blade and shoe to adjust the 90° setting. Adjust the
stop (N) using an hex key.
Replacing the saw blade (Fig. 5)
1. Engage the blade lock button (C) and unscrew the blade clamping screw (O) by
turning counterclockwise using the spanner (P) supplied with the tool.
2. Retract the lower blade guard using the lever (F) and replace the blade (H).
Reinstall the washers (Q, R) in the correct position.
3. Check the direction of rotation of the blade.
4. Thread on the blade clamping screw (O) by hand to hold the washer in position.
Turn clockwise.
5. Press the blade lock button (C) while turning the spindle until the blade stops rotating.
6. Tighten the blade clamping screw firmly using the spanner.
Mounting and adjusting the parallel fence (Fig. 6)
The parallel fence (M) is used for cutting parallel to the edge of the workpiece.
Mounting
1. Slacken the locking screw (S) as to allow the parallel fence to pass.
2. Insert the parallel fence (M) in the saw shoe (E) as shown.
3. Tighten the locking screw (S)
.
Adjusting
1. Slacken the locking screw (S) and set the parallel fence (M) to the desired width.
2. Tighten the locking screw (S).
Prior to operation:
• Make sure the guards have been mounted correctly. The saw blade guard must
be in closed position.
• Make sure the saw blade rotates in the direction of the arrow on the blade.
• Do not switch the tool on or off when the saw blade touches the workpiece or
other materials.
• Do not operate the spindle lock while the tool is running.
P
O
Q
H
G
R
F
C
S
M
FIG. 6
FIG. 5