DeWalt D21101, Руководство пользователя

Страница: 6 / 12

6
E N G L I S H
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D
E
WALT tool is double insulated in
accordance with IEC 60745; therefore no
earth wire is required.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
2
. When using a cable reel, always
unwind the cable completely.
Also refer to the table below.
Conductor size (mm
2
) Cable rating (Amperes)
0.75 6
1.00 10
1.50 15
2.50 20
4.00 25
Cable length (m)
7.5 15 25 30 45 60
Voltage Amperes Cable rating (Amperes)
220-240 0 - 2.0 6 6 6 6 6 6
2.1 - 3.4 6 6 6 6 6 6
3.5 - 5.0 6 6 6 6 10 15
5.1 - 7.0 10 10 10 10 15 15
7.1 - 12.0 15 15 15 15 20 20
12.1 - 20.0 20 20 20 20 25 -
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
The tool can be used in rotary drilling for steel,
wood and plastics.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework
and wiring.
• Apply only a gentle pressure to the tool.
Excessive force does not speed up
drilling but decreases tool performance
and may shorten tool life.
• Use auxiliary handles supplied with the
tool. Loss of control can cause personal
injury.
Prior to operation:
• Insert the appropriate bit.
• Mark the spot where the hole is to be drilled.
Chuck removal (fig. B)
• Open the chuck jaws as far as possible.
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
• Insert a screwdriver into the chuck and remove
the chuck retaining screw (9) by turning
clockwise.
• Tighten an Allen key into the chuck and strike it
with a hammer as shown.
Forward/reverse slider (fig. A)
• To select forward or reverse rotation, use the
forward/reverse-switch (3) (see arrow on tool).
Inserting and removing a bit (fig. A)
Keyed chuck
• Open the chuck by turning the sleeve (6)
counterclockwise and insert the bit shank.
• Put the chuck key (7) into each hole in the side
of the chuck and turn clockwise until tight.
• To remove the bit, proceed in reverse order.