DeWalt 621106-00, Инструкция по эксплуатации

Страница: 11 / 44

English
9
Brushes should be regularly inspected for wear. To inspect brush-
es, unscrew the two end cap screws (W) and remove end cap (X).
Remove brush cap (Z). Brushes (Y) should slide freely in brush
box. If brushes are worn down to .3" (8mm) as shown in Figure 10
they should be replaced. To reinstall, push new brush back into
brush box. If replacing existing brush, maintain same orientation as
when removed. Replace the brush cap (
do not overtighten ).
Replace end cap and two screws. Tighten securely.
Cleaning
Blowing dust and grit out of the main housing by means of an air
hose is recommended and may be done as often as dirt is seen
collecting in and around the air vents. Always wear proper eye
and respiratory protection.
Repairs
To assure product SAFETY and RELIABILITY, repairs, mainte-
nance and adjustment should be performed by authorized service
.3"
(8mm)
Y
Z FIG. 10
W
X
Y
centers or other qualified service organizations, always using iden-
tical replacement parts.
NOTE: Unit may be converted to a 3-wire twist lock cord set at an
authorized service center.
Lubrication
Closed-type, grease-sealed ball bearings are used throughout.
These bearings have sufficient lubrication packed in them at the
factory to last the life of the chop saw.
Accessories
CAUTION: The use of any other accessory not recommended
for use with this tool could be hazardous.
Use only high-strength Type 1 organic bonded wheels rated 4100
rpm or higher.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating your local dealer or authorized service
center contact: D
E
WALT Industrial Tool Co., 701 East Joppa Road,
Baltimore, MD 21286 or call 1-800-4-D
E
WALT (1-800-433-9258).
Three Year Limited Warranty
D
E
WALT will repair, without charge, any defects due to faulty mate-
rials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-D
E
WALT. This
warranty does not apply to accessories or damage caused where
repairs have been made or attempted by others. This warranty
gives you specific legal rights and you may have other rights which
vary in certain states or provinces.
In addition to the warranty, D
E
WALT tools are covered by our:
1 YEAR FREE SERVICE
D
E
WALT will maintain the tool and replace worn parts caused by
normal use, for free, any time during the first year after purchase.