Devolo dLAN 200 AVpro i, Руководство пользователя

Страница: 15 / 31

|
devolo dLAN 200 AV software
15
|
devolo dLAN 200 AVpro i
|
If a device that has been switched off (e.g. a computer) is connected to the Eth-
ernet port, a dLAN 200 AVpro i device switches to Power Save mode after about
20 minutes. In Power Save mode, the dLAN 200 AVpro i device cannot be
accessed via the power supply grid or the coaxial network. As soon as the device
that is connected to the Ethernet port is switched on again, your
dLAN 200 AVpro i is available again via the power grid or the coaxial network.
햴
In the following dialog box, select a shared identifier for your
dLAN 200 AVpro i network, and click
Next to confirm.
The default identifier set by devolo is HomePlugAV (note upper and lower
cases).
햵
The dLAN 200 AVpro i that is connected directly to your computer will be
found automatically. All other dLAN 200 AVpro is must be registered man-
ually. To do this, enter the Security IDs of the dLAN 200 AVpro is that are to
be combined in a network one after the other, and click on
Add . Click Next
to confirm when you have entered all the dLAN 200 AVpro is you wish to
add.
햶
To exit the Security setup for your network, click on Finish . All the
dLAN 200 AVpro i adapters that are entered in the list will receive the same
ID. All dLAN 200 AVpro i adapters that have the same ID can exchange data
among themselves. Adapters that have been installed on the same power
supply grid or coaxial network, but which use different IDs, cannot commu-