SPECIFICATIONS
Max. Air Pressure:
0.9 Mpa (9.0 bar)
Max. Fluid Pressure:
1.4 Mpa (14.0 bar)
Cylinder Air Pressure:
Min. 0.34Mpa (3.5 bar)
Max 0.49Mpa (5.0 bar)
Weight:
270g (T-AGB-862)
550g (Stainless Body Type)
Gun Stud Diameter:
10.5mm
Fluid Thread:
R1/8 (F) CAP Thread:
R1/8(F)
FAN Thread:
R1/8 (F) CYL Thread:
R1/8(F)
INSTALLATION
Figure 1. Dimensions
Figure 2. Air Circuit Example
Mounting the gun with the stud (21) or tighten with M8(F) of the gun body.
CAUTION:
The air supplied to the gun should be clean air that removed any impurities. Also, the air hose should
have enough inner diameter depending on the length to supply necessary air.
As CYL air is not consumption air, large diameter of the tube is not necessary.
When circulating the paint, remove the plug and install the fluid nipple.
OPERATION
1. Mix, prepare and strain the coating material to be sprayed according to paint manufacture’s instructions.
2. Adjust the CYL air at 0.34~0.49 Mpa.
3. Turn the Adjusting Screw (20) counter-clockwise 3.5 turns from fully closed position and fixed with Lock
Nut (19). This makes the Needle fully opened.
4. Adjust the CAP/FAN air at about 0.35Mpa.
5. Adjust the Fluid pressure at 0.07~0.1Mpa.
6. Turn on CYL air and test spray. Adjust fluid and air pressure until desired pattern is obtained. Control
fluid pressure at source supply. Always attempt to keep CAP pressure as low as possible to minimize
overspray.
(27)
FLUID
R1/8
(92)
FLUID
R1/8
(37)
FAN
R1/8
CAP
R1/8
CYL
R1/8
7
.5
18
40
φ
10
.5
7.
5
Air Regulator
CAP
FAN
CYL
Pilot Valve
Speed Controller
3-way Valve
On/Off (Manual)
Shuttle Valve
On/Off (Automatic)
Solenoid Valve
7.5
18
４０
7.
5
7.
5
－
4
－
