11- ENG
D24152
MAINTENANCE
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and
bearing uses compressed air to power the tool. Because moisture in
compressed air will rust the air motor, you must lubricate the motor daily. An
inline oiler is recommended.
To lubricate the air motor manually:
l
Remove chisel.
l
Disconnect the tool from the air supply holding it so
the air inlet faces up.
l
Depress the trigger and place one to two drops of air
tool oil in the air inlet Depressing the trigger helps
circulate oil in the motor.
NOTE
: Use SAE #10 weight
oil if air tool oil is not available.
Keep out of the reach of
children. If taken internally, do not induce
vomiting, call a doctor immediately or contact your local poison
control center.
l
Connect the tool to an air source, cover the exhaust end with a towel and
run for a few seconds.
Any excess oil in the motor is immediately
expelled from the exhaust port. Always direct
exhaust port away from people or objects.
Failure to lubricate the tool at the air inlet will
void your warranty.
