A common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by unplugging the appliance and
vacuum-cleaning air vents and grilles, where available.
Do not use this appliance in a window as rain may cause electric shock.
Do not use abrasive cleaning products on this appliance. Clean with a damp cloth
(not wet) rinsed in hot soapy water only. Always remove plug from the mains
supply before cleaning.
Do not connect the appliance to the mains source until it has been installed in its
final location and adjusted to the position it will be used in.
This appliance is not intended for use in bathrooms, laundry or similar locations
which may be exposed to water, moisture or humidity.
Do not operate with the cord coiled up as this could cause a build up of heat,
which could pose a hazard.
The use of an extension cord with this appliance is not recommended.
Do not remove the power plug from the socket by pulling the cord
– grip the plug
instead.
Always unplug appliance when not in use.
Do not allow cord to come in contact with heated surfaces during operation.
Do not run cord under carpeting, throw rugs or runners etc. Arrange cord away
from areas where it is likely to be tripped over.
Do not twist, kink or wrap the cord around the appliance, as this may cause the
insulation to weaken and split. Always ensure that the cord has been fully
removed from any cord storage area before use.
Do not store appliance in a box or closed space until it has cooled down
sufficiently.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Young children should be supervised to ensure they do not play with the
appliance.
The appliance must not be located immediately below a socket-outlet.
Do not use this appliance with a programmer, timer or any other device that
switches the heater on automatically, since a fire risk exists if the appliance is
covered or positioned incorrectly.
If the supply cord is damaged, it must be replaced by a qualified electrical person
in order to avoid a hazard.
Do not use this appliance outdoors, or on wet surfaces. Avoid spilling liquid on
the
appliance.
In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
WALL INSTALLATION
The Heater:
Must not be mounted less than 1.8m above the floor.
Must not be mounted less than 0.5m away from side wall(s).
Drill two holes in brick wall both at a distance of
39.4
m apart and at least 1.8m from
the ground (
t
he supplied wall fixings are for brick walls; for other wall types, please
consult your local hardware store)
. T
he diameter of the holes should just
tightly contain the plastic wall plug. When the wall plugs are securely in the wall,
screw the provided screws into the wall plugs. If you are satisfied that the screws will
now hold the weight of the heater, hang the heater on the screws.
Feature
