DEUTSCHMANN AUTOMATION UNIGATE IC, Инструкция по эксплуатации

Страница: 39 / 48

5.7.13 Instruction manual UNIGATE
®
IC - Ethernet V. 2.9 39
Deutschmann Automation GmbH & Co. KG Appendix
P 16
All digital outputs of the shift registers are available here. Additionally the LEDs D9, D15..D18,
D20 are connected to the shift registers.
P 17
With P17 the UNIGATE® IC can be brought into the configmode. If the jumper is plugged and if
the UNIGATE® IC is restarted (by power off and power on or by reset), then the UNIGATE® IC
will start in the configmode. In order to use the configmode with Deutschmann software tools the
interface of the board has to be in RS232-position and the PC has to be connected with the „nor-
mal“ interface, where otherwise your application is connected to.
See also chapter 7.2.
SW1H, SW1L, SW5H, SW5L
The rotary switches SW1H, SW1L, SW5H, SW5L are plugged into the base boards and can be
removed if required. As a default the rotary switches are plugged in and can be read in through
the basis board’s shift registers base boards (see also chapter 5 for it).
SW3, SW4
These switches are required for the setting of the serial interface. The switch SW3 is used to
switch between interface RS232 and RS485. This is the interface, the customer’s device is con-
nected to. The Debug-interface always has RS232-level.
The switch SW4 is of importance only, when it is an RS485-interface. Then this switch can be
used to connect the termination of the RS485-bus.
Each switch position can be taken from the illustration.
D12
Power LED
This LED is always supposed to be shining statically green when the board is supplied with volt-
age.
D9, D15..D18, D20
LEDs that are connected to the shift register components. See also (see also chapter 14.2.4
’Wiring diagram UNIGATE® IC-basis board Ethernet’).