DEUTSCHMANN AUTOMATION UNIGATE IC-DeviceNet, Инструкция по эксплуатации

Страница: 42 / 48

9.2.22 Instruction manual UNIGATE
®
IC - DeviceNet V. 4.0 42
Deutschmann Automation GmbH & Co. KG Accessory
13 Accessory
The following tools are available from Deutschmann Automation.
13.1 FirmwareDownloadTool (FDT)
The FirmwareDownloadTool is available for download from our homepage: it is required for an
update of the firmware. Condition for it is, that a PC can be connected to the serial of the IC. The
software describes the procedure of an update itself.
13.2 Protocol Developer
The Protocol Developer is the development environment for scripts, that also contain the Debug-
ger. This software package also contains the documentation to all script-commands. This soft-
ware is available for download from our homepage at http://www.deutschmann.de. The
instruction manual for the Protocol Developer, which is available in pdf-format, gives further
advise on how to use the software.
13.3 Developer Kit UNIGATE
®
IC-AB IC
The Developer Kit IC contains
• a Developer Board UNIGATE
®
IC (see chapter 13.3.1)
• a plug-in power pack to supply the Developer Board
• connection cables for appl. RS232, Debug RS232 and appl. RS422/485
• USB-cable
• Software and documentation to complete the packet.
13.3.1 Developer Board UNIGATE
®
IC-AB
The Developer Board was developed so that the fast implementation of the Deutschmann All-in-
one bus node UNIGATE
®
IC into your electronic system can be guaranteed. The board is suit-
able for all Fieldbuses and Industrial Ethernet Buses supported by Deutschmann Automation.
The required UNIGATE
®
IC / ICs are ordered separately. The required voltage (5V or 3.3V,
depending on the version) can be adjusted. An RS232-interface or a USB-connection is avail-
able for the connection to the PC (Debug-interface).
The application can be connected either through the USB, RS232, RS485 or the RS422.