D.
Push back end of braid as shown.
E.
Carefully comb back braid over end nut to expose dielectric.
F.
Push braid ring onto end nut to trap braid. This should be a tight fit. Trim back excess strands of braid.
G.
Push rear insulating bush onto dielectric until it butts up against braid ring. Make a small mark on the dielectric flush with the end of the
rear insulating bush.
H.
Remove rear insulating bush and cut of dielectric at point where mark was made. Ensure that conductor is not damaged. Replace rear
insulating bush and trim conductor to a length of 2mm.
J.
Solder contact onto conductor using solder hole. (see appendix)
K.
Push front insulating bush onto rear insulating bush.
L.
Tighten end nut in connector until it is approximately flush with rear of connector.
Soldering Wire to Contacts
i)
Apply heat (approx. 370°C soldering iron) to the contact approximately 180° from solder hole.
ii)
Feed solder (60/40 with R or RMA Flux) into solder hole. Allow to cool.
iii)
Inspect to ensure there are no sharp spikes or dry joints.
Deutsch Ltd
Castleham Industrial Estate
2 Stanier Road
St Leonards on Sea
East Sussex
TN38 9RP
England
Telephone
+44 (0) 1424 852722
Fax
+44 (0) 1424 855979
www.deutschltd.com
