Detroit Diesel 4000 Series, Руководство по обслуживанию, Страница: 263 / 2706

SERIES 4000 12/16V SERVICE MANUAL
Removal of Oil Pan (In Chassis)
Perform the following steps for the removal of the oil pan (in chassis):
1. Drain engine oil from both the oil pan and gear case.
2. Inspect installation and using OEM recommendations remove any necessary truck
components that may interfere with the removal of the oil pan.
3. Remove the lube oil filler dipstick assembly from the side of the cylinder block and
inspect for damage. Care should be taken to protect the dipstick and tube assembly from
damage during storage.
4. Remove ECM mounting bolts and store the ECM out of the way of the main bearing
stabilizer bolts. Care should be taken to protect the ECMs and harnesses
5. Install a floor jack that has been modified to cradle the oil pan at the center of the oil
pan. See Figure 90.
Figure 90 Installing Floor Jack
6. Remove all oil-pan-to-gear case attaching bolts. Remove all remaining oil pan bolts and
spacers. Slowly lower front end of oil pan allowing remaining oil in the pan to drain.
NOTE:
Capture any foreign material that may flush out at this time.
7. Rest the rear end of the oil pan on the truck front cross member. Relocate jack to front end
of the oil pan. Lower front end of oil pan to lowest position of jack. Slide pan forward and
lower rear end of pan to the floor. Remove front end of the oil pan to the floor. rRemove
the oil pan from under the engine.
All information subject to change without notice.
Copyright © DETROIT DIESEL CORPORATION
C -117