Page
6
of
17
STEP 4.
Push Pushpad and hold device with both hands. While keeping pushpad pushed, pull at
hinge side end away from door (1), swinging the device against center case mount plate to
disengage tabs and allowing device to pull free from mounting plate (2). Place device on a flat
surface covered with a clean, soft cloth to avoid scratches or surface contamination.
STEP 5.
Uninstall mount plate removing screws shown below. These screws are also used to
hold Outside Trim; if installed, it must be supported while removing screws. There are 3
different screw options that can be used during installation depending on device model used.
NO NEED TO REMOVE BACKPLATE
(4x) #1/4 STAR LOCK
WASHER
DTX #PP-5067-25
(4x) ¼-
20x1.0” PPH DTX #100980, or
(4
x) #14 x 1.0” PPH SELF DRILLING #103276
-63, or
(4
x) #14 x 1.25” PPH WD SCREW #PP
-5183-110
10 SERIES MOUNT PLATE
40 SERIES MOUNT PLATE
Door hinge side
(2)
(1)
Mount plate
