9
W A L K S T A T I O N
U S E R
I N S T R U C T I O N S
Walking Platform Operation
• Start – Press START to start belt moving.
• Stop – Press STOP to stop belt moving.
• Pause – Press STOP to stop belt moving & hold session information on display.
• Reset – Press and hold STOP for at least 3 seconds at any time
during operation or pause.
• Emergency Stop – Pull off magnet on end of Magnetic Safety Clip from its
indicated connection on keypad. Belt will slow and stop.
3 Pre-set Programmable Height-AdjusTable Table Controller
(Sit-to-Walkstation only)
Operating the Height-AdjusTable Table Controller
The table control panel has six buttons for user control.
• Press and hold either the Up or Down arrow to reach the desired height.
As a safety feature, the user must continuously hold down the button in
order for the table to move.
• The buttons labeled 1-3 each store a desired pre-set height into the
control panel memory.
• The S button is used to store the desired pre-set height for each button labeled 1-3.
Store Height into Memory
To set into memory the desired height for either seated, standing, or walking
work, use the three pre-set buttons.
• Press either the Up or Down arrow until the desired height is attained.
• Press and hold the S button along with your choice of buttons 1-3 to set that
particular height. Hold for three seconds.
• To pre-set additional heights repeat this sequence using the remaining 1-3 buttons.
Adjust Table to a Stored Memory Position
To switch to a stored height in memory, use the
three pre-set buttons.
• Press and hold the numbered button that has the pre-set
height stored into memory.
WS_Instructions_TroubleShooting:Layout 1 1/7/10 10:57 AM Page 9