Service
EN
24 / 28
07/2020
Motor align
Click this icon.
Click
Motor align
.
It is mandatory to calibrate the tools after a motor align.
It is recommended to align the motor in case of motor, transducer or PCB change.
Before starting, press the trigger and
KEEP IT PRESSED DURING THE COMPLETE PROCESS
. If not, the
tool could be severely damaged.
While pressing the trigger, click
Start motor align
.
The process will run during around 1 minute and will stop automatically.
Click "Stop motor align" to stop the process before the end.
Release the trigger.
Declaring fixed accessories
A fixed accessory mounted on a tool must be declared in this screen.
Click this icon.
Click
Tool identification
.
Select the type of accessory and fill in the parameters.
Click
Write to tool
.
It is mandatory to calibrate the tool equipped with the fixed accessory before use.
Upgrading tool firmware
Click this icon.
Click
Upgrade tool firmware
.
Contact your Desoutter representative to get the last firmware version.
Follow the instructions on screen.
