20083 / 20084 Page 7
14. PROGRAMMING OPTIONS:
There are 4 options which can be set as described in the Programming Method section
following this section.
A. Horn-vs-Siren
(Factory setting is Horn)
This product gives you the option of having a pulsed output for a car horn or a
constant output for a siren.
B.
Lock Follow Ignition
(Factory setting is "No Lock Follow Ignition")
This option will automatically lock the doors 2 seconds after the car is started,
and will automatically unlock the doors when the key is removed from the igni-
tion.
C. Passive vs Active Arming
(Factory setting is Active Arming)
In the Active arming mode -- the alarm will not arm until you Lock the doors
with the Left button on the transmitter -- 1 chirp will be heard for arming.
Passive arming will arm and lock the vehicle 25 seconds after the key has been
removed from the ignition and all of the doors have been closed. You must still
disarm the system in both modes with the keychain transmitter's Left button -- 2
chirps will be heard for disarm. In passive arming the system will arm the door
pin switch, activate starter-kill, and Lock the doors 25 seconds after the ignition
is turned off AND the alarm has seen the last door close. Pushing the Left button
on the transmitter to control lock will override this passive feature. NOTE: The
doors will automatically Lock after the 25 seconds time.
D. Violet Wire Options: Starter Kill / Domelight / Headlight.
(Factory setting is Starter Kill). If you do not want Starter Kill, this VIOLET
wire can be set for two different functions -- Domelight or Headlights. In the
Dome light mode, the output comes on each time the door is unlocked with the
Right button -- and stays on for 25 seconds or until the ignition key is turned on.
In the Headlights mode the headlights will come on along with the horn/siren
during lock/unlock, panic and alarm. See Option 4 of the Programming Options
on the next page for setting these options.
Page 8 20083 / 20084
15. PROGRAMMING METHOD:
This section will set or reset any of the four options.
1)
Turn the Control Switch (the toggle switch) OFF (down). (The switch has a
dot on the side which is the ON position).
2)
Push the white button on the side of the case of the receiver and the red LED
will flash once letting you know you are in option 1. Push the white button
again to scroll to option 2 (the LED will flash twice) and again for option 3
(the LED will flash 3 times) and again for option 4 (4 flashes) -- then back
to option 1 again if necessary.
3)
When you are at the option you want to change -- simply press the Left,
Middle or Right button on the transmitter to choose the function you want.
After a few seconds of holding the transmitter button down -- the red LED
on the receiver will come on signifying acceptance of new option -- then you
can release the transmitter button and push the white button again to scroll
to the next option or wait 5 seconds for this routine to exit out.
Transmitter Button to be pressed
Left
Middle
Right
Option 1:
Lock Follow Ignition
“No Lock Follow Ignition”
X
“Lock Follow Ignition”
X
Option 2
Passive vs Active Arming
Active
X
Passive
X
Option 3:
Horn vs Siren
Horn
X
Siren
X
Option 4:
Function of Violet Wire
Starter Kill
X
Dome Light
X
Headlights
X
