Page 11
the ignition) and pressing the gas pedal to raise the idle rate to
twice the normal rate. The red LED should turn off. If it does
not turn off, repeat the tach rate learning step and check the
GREEN wire connection and location.
ed/White Wire
Remote Input
Control Harness
D/WHITE wire is used to trigger the Secure Start® to start.
his wire a negative pulse will cause the Secure Start® to start.
another negative pulse will cause it to stop.
s wire up to the output wire of your remote car alarm or keyless
tem. Or, hook it to the lock or unlock wire of your vehicle and
on 8 as described in Section 20.
so be used with the optional Timer module from DesignTech to
vehicle at predetermined times.
ONAL STEPS
the optional steps require a relay to be hooked up. The most
relay used for this type of application is the Bosch type automo-
y P/N 0332 209150. Use the diagrams below for a typical hookup.
e another type of relay, then you need to know that pins 85 and
s diagram represent the coils of the relay. Pin 30 is the common
87 is the normally open contact. If your relay has a pin 87A,
not used for these applications. The diagrams below are typi-
d for applications such as headlamp or parking lamp connec-
Page 12
14. Yellow/Green Wire Alarm Control
Cntrl
The YELLOW/GREEN wire is specifically designed to control
tion Input of the remote control alarm system which is trigge
Secure Start. Connect this YELLOW/GREEN wire to a rela
su12 volts to the Ingnition Input of the alarm. This yel
will turn this relay on anytime it sees +12 volts on the Secur
BLUE IGN 1 wire from the key. Thus this output follows th
status. The only exception is that when the Secure Start is pow
the vehicle this wire will not activate. Thus the alarm remain
tional during Secure Start control -- but not otherwise when
alone is controlling the igntion. This is a 400 mA transistor
output which MUST drive a relay (not included).
15. GREEN/WHITE Sensor Loop IN
Cntrl
GRAY/BLACK Sensor Loop OUT
Cntrl
This GREEN/WHITE wire is the input to a normally closed rela
the Secure Start is running -- this relay opens. Thus if you
external sensor such as a shock sensor -- you can pass this sens
put through the Secure Start. When the Secure Start is runnin
sensor is opened -- or bypassed.
Cut the sensor output wire in half. Connect one side to this G
WHITE wire and the other side of the cut sensor wire to the
BLACK wire.
