6. See diagram above:
A: Using wirenuts, connect white wire from fixture to white wire from house.
B: Connect black wire from fixture to black wire from house.
C: All wirenuts installed to connect wired should be taped in place with
electrical tape to assure they cannot come off accidentally at a later time.
7. Install base of lamp to the 4
"
octagonal base using included screws. In the event your box
is deep in the walls, too deep for included screws, you may obtain longer screws from local
hardware store. Make sure you match threads correctly.
8. Wiring portion is now complete, so you can install bulbs. Again, double check wall switch
is in off position and power is shut off at breaker.
OPERATION
SET-UP AND ADJUSTMENT
Follow these steps to set up your security light for best operation.
1. Turn power switch on and wait 60 seconds for the system’s circuitry to stabilize.
2. Turn the “Time” knob to the fully counter clockwise direction.
3. Aim the control module to the desired target area. Have a person stand approximately in
the center of the target area moving slightly. Moving arms up and down is usually sufficient.
4. Turn the TIME knob clockwise to adjust how long you want the lights to stay on after the
unit is activated. The maximum (full clockwise) is about 10 minutes. The minimum (full
counter clockwise) is about 3 seconds.
5. Remove CDS sticker after TIME adjustment.
SPECIFICATIONS
