DESCO WEST
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178
DESCO EAST
- One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Website:
Desco.com
TB-3065
Page 2 of 4
© 2018 DESCO INDUSTRIES INC
Employee Owned
Features and Components
Operation
NOTE:
• Do not operate the main unit by turning the nozzle
toward a human body, especially to the face or to
the eye of a person. This may cause serious injury
to the person.
• Do not let the nozzle of the main unit touch
conductive or live parts.
• Do not drop the ion gun as it may damage the
piezoelectric power supply embedded in the unit.
• This product emits ozone. Do not use this products
in an enclosed space.
1. Hold the gun approximately six inches from the
surface you want to neutralize and blow off. Aim
the nozzle and hold down the trigger. The green
LED on the back of the gun should illuminate.
Static charges are typically discharged within one
second.
2. Release the trigger when the surface is clean.
Figure 4. Using the Viper Ion Gun
Figure 2. Viper Ion Gun Meter features and components
A
E
B
C
D
F
G
A. Output Air Nozzle:
Outputs ionized air when the
trigger is depressed. Use the Desco
19596
Nitrogen
Nozzle Tip when using nitrogen as the air supply.
B. Hanging Hook:
Use to hang the hand piece when
not in use. The hook may be rotated 90 degrees.
C. Power LED:
Illuminates green when the trigger is
depressed and ionized air blows out the nozzle.
D. Alarm LED:
The red LED will illuminate during the
following conditions:
• the high frequency transformer breaks down and no
longer outputs high voltage
• the high voltage line shorts to ground
• the emitter becomes dirty or contaminated with
moisture or oil
E. Trigger:
Depress to output ionized air.
F. Air Input Port:
Use the one-touch joint to secure a 6
mm air tube to the ion gun.
G. Power Cable:
Connect the power cable to the power
adapter to supply power to the ion gun.
Installation
1. Connect the Viper Ion Gun’s power cable to the
power adapter.
2. Connect the power adapter to an appropriate power
outlet.
3. Connect the green wire to equipment ground. The
face plate screw of a grounded AC wall outlet may
provide a convenient connection point.
4. Insert an air tube (6 mm outside diameter) into the
ion gun’s air input port.
5. Connect the other end of the air tube to a source of
clean dry air or nitrogen.
Figure 3. Installing the Viper Ion Gun
Viper Ion Gun
Power Cable
Power
Adapter
Air Tube (6 mm dia.)
Ground
Wire
