Desa VP20BTB, Инструкция по технике безопасности и установке

Страница: 9 / 52

www.desatech.com 121880-01B 9
8"
(20.3
cm)
Min.
A
dj
oi
ni
ng
W
al
l
A
dj
oi
ni
ng
W
al
l
Only Insert Mounting
Screws Through Last
Hole On Each End
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
Floor
14" (35.6 cm) 14" (35.6 cm)
18 3 /
4
"
(47.6 cm)
Min.
18 3 /
4
"
(47.6 cm)
Min.
12"
(30.4
cm)
Min.
30,000 Btu/hr Models
THERMOSTAT SENSING BULB
The thermostat sensing bulb has been placed
below the heater.
1. Place clamp on thermostat sensing bulb
as shown in Figure 5. Clamp is provided
in hardware package.
2. Snap clamp into upper mounting hole
as shown in Figure 5. Mounting hole is
located on lower left edge on back of
heater. Make sure the thermostat sensing
bulb is pointing up.
Figure 5 - Attaching Thermostat Sensing
Bulb
Clamp
Thermostat
Sensing Bulb
Figure 6 - Mounting Bracket
INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket in heater carton. Re -
move mounting bracket from heater carton.
Figure 7 - Removing Front Panel Of Heater
Removing Front Panel Of Heater
1. Remove the four painted screws, two on
each side of front panel.
2. Pull bottom of front panel forward, then out.
3. Remove any remaining packaging mate
-
rials.
Methods For Attaching Mounting Bracket
To Wall
Only use last hole on each end of mounting
bracket to attach bracket to wall. These two
holes are 14" apart from their centers. Attach
mounting bracket to wall in one of two ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Attaching to Wall Stud: This method provides
the strongest hold. Insert mounting screws
through mounting bracket and into wall studs.
Attaching to Wall Anchor: This method al -
lows you to attach mounting bracket to hollow
walls (wall areas between studs) or to solid
walls (concrete or masonry).
Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall where heater
will be located. Make sure mounting bracket
is level.
WARNING: Maintain minimum
clearances shown in Figure 8. If
you can, provide greater clearanc-
es from floor and joining wall.
2. Mark screw locations on wall (see Figure 8).
Note: Only mark last hole on each end of
mounting bracket. Insert mounting screws
through these holes only.
3. Remove tape and mounting bracket from
wall.
Figure 8 - Mounting Bracket Clearances
8"
(20.3
cm)
Min.
A
dj
oi
ni
ng
W
al
l
A
dj
oi
ni
ng
W
al
l
Only Insert Mounting
Screws Through Last
Hole On Each End
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
Floor
14" (35.6 cm) 14" (35.6 cm)
18
3
/
4
"
(47.6 cm)
Min.
18
3
/
4
"
(47.6 cm)
Min.
12"
(30.4
cm)
Min.
20,000 Btu/hr Models
INsTallaTIoN
Continued
Screw
Front Panel