INSTALLING BLOWER AFTER MOUNTING THE
FIREPLACE
Note:
Fireplace must be properly connected to a 110V power source
before blowers can be operated.
1. Remove three screws that secure side brick retainers. Pull out
side brick exposing blower cover plate on right side of fireplace
(see Figure 5).
2. Remove blower cover plate (see Figure 6).
3. Place blower assembly through hole in firebox. Make sure wire
protrudes through notch in fireplace side. Align two holes on
side of rectangular bracket with two holes on side frame. Secure
with screws provided (see Figure 7). Blower assembly should
now look similar to Figure 8.
4. Before replacing blower cover plate, plug male electrical connec
-
tor on blower assembly into female socket already in fireplace.
Replace blower cover plate, side brick and retainer before using
fireplace.
SPECIAL INSTRUCTIONS FOR GLASS DOORS
If doors are installed, it is necessary to remove the right door and side frame. To remove door, press upper hinge spring in door track and
slide track and slide door assembly to the left. To remove side door frame, remove top and lower most hex head screws securing frame.
Figure 8
ON/OFF Switch
Fireplace Face
Figure 7
Figure 6
Figure 5
Side Brick
Side Brick
Retainer
Fan
Cover
Plate
Knockout
Plate
Rectangular
Bracket
Rectangular
Bracket
Fireplace
Side
Fan Assembly
Firebox
56105
Rev. C
01/06
NOT A UPC
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
56105
For more information, visit www.desatech.com
ON/OFF
Switch Wiring