MODELS: VCBK4R &VCBK4L FAN KIT
INSTALLATION AND OPERATING INSTRUCTIONS
INSTALLING BLOWER BEFORE MOUNTING FIREPLACE
Figure 1
Figure 2
Knockout Tab
Electrical Connection
Fireplace
Rocker Switch
and Wiring
Male Electrical
Connector
Blower
Assembly
Figure 3
Figure 4
Fireplace
Sheet Metal
Screws
Blower
Assembly
Rectangular
Bracket
ON/OFF Switch
Fireplace Face
Note:
Fireplace must be properly connected to a 110V power source
before blower can be operated.
1. Remove large knockout tab (see Figure 1).
2. Align two holes on side of rectangular bracket with two holes
on side frame. Secure with screws provided (see Figure 7).
3. Place blower assembly in fireplace and plug male electrical
connector into female connector already in fireplace. Make sure
rocker switch wire protrudes through notch in fireplace side (see
Figure 2). Connect wires with rocker switch.
4. Take four sheet metal screws provided and secure blower as-
sembly to fireplace through holes (see Figure 3). Blower should
now be in place and look similar to Figure 4.
Note
See instructions on reverse side if FULL VIEW glass doors
are installed.