www.desatech.com
122075-01B
3
Top (#7)
Leg
Assemblies
1
1
/
4
" Screw
Figure 5 - attaching top to Leg and Header assembly
Washer
Back of Top
Flush with
Back of Leg
Assembly
gAs FiRePlAce instAllAtiOn
1. Fireplace should be fully assembled. See
Assembling
Fireplace
in fireplace owner’s manual.
2. Place mantel base close to installation location. See fire
-
place owner’s manual for installation clearances. Leave
enough room to insert fireplace from back of mantel.
3. Install gas line. See
Connecting to Gas Supply
in fireplace
owner’s manual. Remember to leave access to the gas
shutoff valve somewhere on the base or where it is ac
-
cessible to the user.
4. Check for leaks. See
Checking Gas Connections
in fire
-
place owner’s manual.
5. Position fireplace inside mantel (see Figure 6). Carefully
position gas lines. Important: Use caution when position
-
ing fireplace on base. Base may scratch easily. Make
sure fireplace is in proper position within mantel opening
before continuing with installation.
6.
Fireplace with louver door:
Lower bottom louver door.
Use two screws provided in hardware package and attach
fireplace to wooden base. Close louver door.
Fireplace with fixed louver:
Before installing logs or
burner assembly (see owner’s manual) remove screws
securing floor to assembly. Lift floor for access to bot
-
tom of fireplace. Use two screws provided in fireplace
hardware package and attach fireplace base to wooden
base. Reinstall floor with screws removed previously.
7. Carefully push mantel and base into position against
wall.
electRic FiRePlAce instAllAtiOn
This mantel can be used with DESA Heating, LLC's 32" Electric
Fireplace. Electric fireplaces install from the front of mantel.
To install electric fireplace see fireplace instruction manual.
Use caution when positioning fireplace on base. Base may
scratch easily.
mAntel tOP Assembly
Place mantel top (#7) on mantel assembly. Align back of top
with back of sides. Using four 1
1
/
4
" screws with washers, place
two in each mantel side assembly (see Figure 5). With three
1
1
/
4
" screws with washers, attach top to header. Make sure
all pieces are aligned properly and tighten, leaving screws
slightly loose.
Figure 6 - Installing Fireplace