www.desatech.com
114668-01F
18
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify logs.
Only use logs supplied with heater.
1. Place ember bed in center of base assem-
bly as shown in Figure 23. The ember bed
must rest against the metal stop on the left
and screw on the right. It is very important
that ember bed be seated correctly.
INSTALLATION
Continued
Base
Assembly
Figure 24 - Installing Rear and Middle Logs
Ember
Bed
Note: Your appliance may vary from model
shown but log placement will be the same.
Rear
Log
Middle Log
Figure 23 - Installing Ember Bed
Metal Stop
Screw
Stop
2. Rest rear log in back corner sections of
base assembly as shown in Figure 24.
Make sure log is completely vertical and
not leaning in toward burner where the
flame will touch the log.
3. Position middle log as shown in Figure
24, making sure grooves in bottom of log
fit over grate prongs. This log will rest on
top of bottom log.
4. Place top right log onto pins of middle log
(see Figure 25). The bottom of the top log
will rest on the middle log as shown in
Figures 25 and 26.
5. Place top left log on middle log as shown
in Figure 25.
6. Place right and left front logs against grate
as shown in Figure 26 to hide controls.
Figure 25 - Installing Top Logs
Figure 26 - Installing Front Logs
Middle
Log
Top Left Log
Top Right Log
Left
Front
Log
Right Front Log
