14
105616
VENT-FREE PROPANE COMPACT FIREPLACE
OPTIONAL WIRELESS
HAND-HELD REMOTE
CONTROL ACCESSORIES
(CGHRC Series and
CGHRCT Series)
Installing Receiver
1.
Remove screws.
2.
Disconnect switch wires from the con-
trol valve.
3.
Remove switch plate (see Figure 22).
Discard switch plate after removing.
Save the screws.
4.
Locate the battery clip mounted on the
back of the receiver (see Figure 23).
5.
Slide 9-volt battery (not included)
through the clip.
6.
Attach the terminal wires to the battery
(see Figure 23).
7.
Connect wires as shown in Figure 24.
8.
Install remote receiver unit onto gas
heater base using the two screws re-
moved in step one (see Figure 24).
Figure 22 - Switch Plate and Wiring
Harness
Screw
Switch Plate
Black Wire
Red Wire
Figure 23 - Attaching Battery to Receiver
Battery Clip
9-Volt Battery
Receiver
Terminal
Wires
INSTALLATION
Continued
Figure 24 - Installing Remote Receiver
* Wire harness provided in the fireplace
hardware pack.
Installing 9-Volt Battery in Hand-
Held Remote Control Unit
1.
Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to the battery (not
included). Place battery into the battery
housing.
3.
Replace battery cover onto remote con-
trol unit.
Figure 25 - Installing Battery in Hand-
Held Remote Control Unit
Remote
Receiver
Wires from
Valve
Wire Harness*
Black Wire
Red Wire
Red Wire
Black Wire
Battery
Cover
9-Volt
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
Heater Base
