www.desatech.com
116863-01B
8
OPERATING
INSTRUCTIONS
Continued
IMPORTANT: To control the
electric fireplace by remote, the
Main ON/OFF power switch on
the fireplace must be in the OFF
position; the remote control will
NOT work if the manual ON/OFF
switch is in the ON position.
2. When operating the remote control, it must
be pointed at the logset inside the electric
fireplace and a beep must be heard each time
you press a function button. The beep con-
firms the remote control is performing the
function you have requested.
Note:
Make
sure your batteries are fully charged and
installed correctly in your remote control.
3. POWER ON/OFF button at the top left is
the main ON/OFF power button. Pressing
this button you will hear a beep; this acti-
vates the power to the unit.
Note:
If the
flame does not come immediately, press the
DISPLAY ON/OFF button.
4. The two LOGSET buttons control
the brightness of ember bed, which
changes the brightness of your logset.
To increase the brightness
, press and re-
lease the BRIGHTER button. Each time
you press this button you will hear a beep,
and the brightness will increase by a small
amount, until the maximum is reached.
To decrease the brightness
, press and release
the DIMMER button. Each time you press
this button you will hear a beep and the
brightness will decrease by a small amount,
until the minimum brightness is reached.
5.
Heater Button:
To activate the heater,
press the heater button, then press HI,
MED or LO. The heater is per-set to the
following temperatures:
HIGH will shut off when room reaches
approximately 86° F (30 C)
MED will shut off when room reaches ap-
proximately 75° F (24 C)
LO will shut off when room reaches
approximately 64° F (18 C)
6. To adjust the intensity of the flame,
press the two buttons labeled HIGH-
ER and LOWER under FLAME.
To increase the flame intensity,
press
and release the HIGHER button. Each
time you press the button you will hear a
beep and the size of the flame will increase
slightly until the maximum setting is
reached.
To decrease the flame intensity,
press
and release the LOWER button. Each time
you press this button you will hear a beep
and the size of the flame will decrease slight-
ly until the minimum setting is reached.
7. To use the fireplace as a heater without
the flame, press the LOGSET DISPLAY
ON/OFF button to turn the flame off and
press the HEATER ON/OFF button to turn
the heater on (if the heater was in the OFF
position). Press the LOGSET DISPLAY
ON/OFF button again to turn the flame
back on. Press HEATER ON/OFF button
again to turn the heater off.
Note:
You may have to re-adjust your
desired flame setting (see step 6).
FLAME
TEMP. CONTROL
POWER
ON/OFF
ON/OFF
ON/OFF
HIGH
HIGHER
MED
LOW
LOWER
Dimmer
Brighter
EMBERS/
LOGSET
HEATER
DISPLAY
Indicator
Light
Infrared
Ray Exit
Figure 5 - Remote Control For Electric
Fireplace
