www.desatech.com
118419-01E
6
aSSemBly
Continued
Figure 2 - Attaching Wire Guard
Wire Guard (Canadian Models)
1. Remove two screws securing front of up-
per shell to lower shell (see Figure 2).
2. Place wire guard on top of upper shell
flange.
3. Insert screws through wire guard and up-
per shell flange. Tighten screws firmly.
Wire
Guard
Upper Shell
Wire Guard Screws
(Canadian models only)
Rear
Cross
Support
Bolt (A)
Figure 3 - Attaching Rear Cross Support
Wheel and Handles
IMPORTANT:
Install hardware finger tight only
at this time. After assembly is complete, use
tools to tighten entire assembly
1. Place heater with bottom of tank flat on
floor.
2. Attach rear cross support with two bolts
(A), see Figure 3.
3. Push rubber feet onto each leg (left and
right), see Figure 4.
Figure 4 - Rubber Feet and Legs
Figure 5 - Legs Attached to Rear Cross
Support
Bolt (A)
Rear Cross Support
Leg
Axle
Wheel
Figure 6 - Wheel and Axle
Spacer
(B)
4. Assemble each leg (left and right) onto
each side of rear cross support. Loosely
secure each side with bolts (A) (see Fig-
ure 5).
5. Lift front of heater so it is resting on back of
shroud and back of legs (see Figure 8).
6. Insert axle through wheel. Slide one
spacer (B) onto each end of wheel axle.
See Figure 6.
