Page 9
Mount the front dress panel to the front panel sup-
port bracket.
1) Slide a 0.150 white spacer over each of the six
studs on the back of the front dress panel.
2) Insert the batons from the switches into the
front panel and work the studs into the holes on
the front panel support bracket until the front
panel and support bracket have fully sand-
wiched the spacers.
3) Work the front panel down around the switch
bushings as needed until the front panel is flat
and even over all 25 switches. When properly
assembled, the bushings generally protrude just
slightly above the surface of the front panel.
4) Install a #6 nut over each of the studs on the back side of the support bracket(do not tighten). A
shallow 5/16” nut driver makes this job easier.
5) Incrementally tighten the nuts – one on the far left, then one on the far right, working back to the
middle, then repeat tightening each nut a bit more.
