Deprag 339269 A, Руководство по эксплуатации

Страница: 17 / 36

17
1. Put the motor- and gearing package as well as the valve housing
3265002 together and slide the motor housing 323683 resp. 325349 over
them until thread stops.
2. Put the pressure pin 460778 into the valve bushing 328050 and use the
pressure pin to screw in the valve housing 3265002 (right-hand thread).
3. Insert the pressure spring 321746 and the reverse slide 328051 into the
valve bushing, press in the bearing needle 802331 and screw in the
threaded pin 800565 (right-hand thread).
4. Assemble the valve pin 325139 resp. 325761.
5. Mount the valve plate 326498 and the pressure spring 324117.
6. Clamp the motor housing 323683 resp. 325349 by means of the chuck-
ing jaws 460636 into a vice and assemble the complete air inlet 326501
A by means of plier 461289 or hook 323688 (right-hand thread).
7. Insert clutch 337310 A resp. 347227 A into clutch bearing 337333 and
screw the latter on to the screwdriver (left-hand thread).
ATTENTION
The hex of the clutch shaft must engage with the hex of the gear
support resp. spindle (located in gearing).
Check this and ensure that engagement lift on the spindle is
available (appx. 1,5 mm)!
6.1. Special Repair Tools (Optional Equipment)
N
AME
P
ART
N
O
.
Fixing device (for rotor cylinder 323692) 461343
Arbor (to disassemble bearing cover with groove ball bearing) 462329
Plier (for threaded fitting 326497) 461289
Chucking jaws (for motor housing 325349) 460636
Pressure pin (to press out the reversal and to loosen the valve
housing 3265002) 460778
Allen key AF 1,3 (for threaded pin 800565) 824491
Arbor (to assemble circlip 800291 into clutch) 460537
Allen key AF 6 (for motor- and gearing package) 800449
Pressure pin (to disassemble bearing needle 802331) 461367